In our modern agricultural production, the appearance of the organic fertilizer crusher saves manpower and labor for the majority of farmers, but do you really know the organic fertilizer crushing equipment? In the production process of organic fertilizer, do you know the common sense of the use of organic fertilizer crusher? This article will introduce some points in the use process
After the factory installation is completed, before the operator starts production, please read the product description carefully, understand the structure principle, be familiar with the working performance, operate in strict accordance with the operating procedures, and conduct patrol inspections on time. Also keep the following in mind:
1. The crusher and power unit should be installed firmly. If the crusher is fixed for a long time, it should be fixed on the cement foundation; if the pulverizer is a movable operation, it should be installed on the base made of cement, and ensure that the power engine (diesel engine or electric motor) and the crusher are connected to each other.
2. After the crusher is installed, check the fastening of the fasteners, and tighten them if they are loose. At the same time, check whether the belt tightness is appropriate.
3. Before starting the crusher, first turn the rotor by hand to check whether the claws, hammers and the rotor operate flexibly and reliably, whether there is any collision in the shell, whether the rotation direction of the rotor is consistent with the direction indicated by the arrow of the machine, and whether the power machine and the crusher are in the same direction. Whether the machine lubrication is good.
4. Do not replace the pulley at will, to prevent the explosion of the operating room due to the high speed, or the speed is too low to affect the working efficiency of the pulverizer
5. After the crusher is started, it should be idling for 2 to 3 minutes, and then start feeding and work if there is no abnormal phenomenon.
6. Pay attention to the operation of the pulverizer at any time during the work. The feeding should be uniform to avoid traffic jams,and do not overload the work for a long time. If it is found that there is vibration, noise, high temperature of the bearing and the body, and material spraying out, it should be stopped immediately for inspection, and the work can be continued after troubleshooting.
Post time: Oct-15-2021